Saturday, October 10, 2009

Fabbing Transmission Mount!!!!!!

With the engine mounts done and the 4th tab built for the power steering gear box, I then primed all of them with the black KBS paint.
I then set the engine back in place. Everything fit perfectly in to my new motor mounts!
Next i started to fab up a tranmission mount. I used a piece of angle iron and some quarter inch flat stock to raise the center up to where the tranmission will rest on it.
The transmission mount is almost complete. I'm going to weld on some additional supports, cut it to fit, and then bolt it into place tomorrow!

No comments: