New Studs for the Ram Horns!

So much to do, so little time....... I sandblasted the ram horn headers and then had to use my neighbors blow torch to heat them up to remove the old rusted studs.

With the studs removed, I then used a 3/8 - 16 tap to clean out the threads.

The new studs went in fairly well. One side I could only get them to screw in about half as far as they FULLY could go. The other side screwed in very easy.

Next they will be bolted back on to the engine and the exhaust mockup will begin!!!!!!! I now have all the parts, just need more TIME!