I've been working on getting the engine perfectly positioned to create the engine mounts. I first had to weld 2 pieces of quarter inch flat stock together to form one 2.5" wide piece of flat stock.
I then squared the engine up with the frame and leveled side to side and front to back.
Where I will be welding my mounts into place, I had to grind off the paint leaving a nice smooth clean metal surface. This was done on both the passenger and driver side.
Tomorrow night I will be welding the mounts in to place. With the engine permanently mounted, next up will be the exhaust.
I then squared the engine up with the frame and leveled side to side and front to back.
Where I will be welding my mounts into place, I had to grind off the paint leaving a nice smooth clean metal surface. This was done on both the passenger and driver side.
Tomorrow night I will be welding the mounts in to place. With the engine permanently mounted, next up will be the exhaust.
No comments:
Post a Comment